Displays port load-sharing groups, or LAGs.
This command has no arguments or variables.
N/A.
Output from this command displays the following information:
Following is sample output displaying link aggregation on a switch:
show port sharing Load Sharing Monitor Config Current Agg Min Ld Share Ld Share Agg Link Link Up Master Master Control Active Algorithm Group Mbr State Transitions ============================================================================== 14 <2 L2 14 - R 0 L2 15 - A 1 L2 16 - R 0 17 35 Static 1 L2 17 - R 0 L2 35 Y A 1 ============================================================================== Link State: A-Active, D-Disabled, R-Ready, NP-Port not present, L-Loopback Minimum Active: (<) Group is down. # active links less than configured minimum Load Sharing Algorithm: (L2) Layer 2 address based, (L3) Layer 3 address based (L3_L4) Layer 3 address and Layer 4 port based (custom) User-selected address-based configuration Custom Algorithm Configuration: ipv4 L3-and-L4, xor Custom Hash Seed: Switch MAC address (0x969BF582) Number of load sharing trunks: 2
This command was first available in ExtremeXOS 10.1.
The LACP feature was added in ExtremeXOS 11.3.
The Health Check LAG was added in ExtremeXOS 12.1.3.
The round-robin algorithm was added in ExtremeXOS 12.5.
Support for the Min Active parameter was added in ExtremeXOS 15.7.1.
Custom hash seed information was added in ExtremeXOS 30.1.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.