Displays global OSPF information.
This command has no keywords or argments.
N/A.
Not applicable.
The following command displays global OSPF information:
show ospf
The following is sample output from this command:
OSPF : Disabled MPLS LSP as Next-Hop: No RouterId : 0.0.0.0 RouterId Selection : Automatic ASBR : No ABR : No ExtLSA : 0 ExtLSAChecksum : 0x0 OriginateNewLSA : 0 ReceivedNewLSA : 0 SpfHoldTime : 3 Lsa Batch Interval : 30s CapabilityOpaqueLSA : Enabled 10M Cost : 22 100M Cost : 20 1000M Cost (1G) : 19 2500M Cost (2.5G) : 18 5000M Cost (5G) : 17 10000M Cost (10G) : 16 25000M Cost (25G) : 15 40000M Cost (40G) : 13 50000M Cost (50G) : 12 100000M Cost (100G) : 10 ASExternal LSALimit : Disabled Timeout (Count) : Disabled (0) Originate Default : Enabled Always : Yes Type: 2 Cost: 10 Tag: 0 SNMP Traps : Enabled SNMP Trap Bit Map : 0xffff VXLAN Extensions : Enabled Redistribute: Protocol Status cost Type Tag Policy direct Disabled 0 0 0 None static Disabled 0 0 0 None rip Disabled 0 0 0 None e-bgp Disabled 0 0 0 None i-bgp Disabled 0 0 0 None isis-level-1 Disabled 0 0 0 None isis-level-2 Disabled 0 0 0 None isis-level-1-external Disabled 0 0 0 None isis-level-2-external Disabled 0 0 0 None host-mobility Enabled 0 2 0 None
This command was first available in ExtremeXOS 10.1.
The SNMP Traps and 40G parameters were added in ExtremeXOS 12.6.
This command is available on platforms with an Advanced Edge or Base license, or higher, as described in the ExtremeXOS 32.1 Feature License Requirements document.