Display specific details for an ERPS ring.
ring-name | Alphanumeric string that identifies the ERPS ring. |
N/A.
Use this command to display specific details for an ERPS ring.
The following example displays details for an ERPS ring named "R1":
# show erps "R1" Name: R1 Operational State: Protection enabled Node Type: RPL Owner, Revertive Configured State : Enabled East Ring Port : 21 MepId: 1 Remote MepId: 3 Status: Blocked West Ring Port : +20 MepId: 2 Remote MepId: 4 Status: Blocked Periodic timer interval: 5000 millisec (Enabled) Hold-off timer interval: 0 millisec (Enabled) Guard timer interval : 500 millisec (Enabled) WTB timer interval : 5500 millisec (Enabled) WTR timer interval : 1000 millisec (Enabled) Ring MD Level : 1 CCM Interval East : 1000 millisec CCM Interval West : 1000 millisec Notify Topology Change : ------- Subring Mode : Virtual Channel ERPS Control Vlan: cvl VID:1000 Topology Change Propogation List: None Topology Change Propogation : Disabled ERPS Ring's Sub-Ring(s): None ERPS Ring has following Protected Vlan(s): Vlan Name VID pvl 1001 Number of Protected Vlans: 1 (+) RPL Protection Port, (^) RPL Neighbor Port (f) Force Switch Port, (m) Manual Switch Port
This command was first available in ExtremeXOS 15.1.
This command is available on all platforms supported in 12.6 and forward that are running ExtremeXOS.