show rip interface

show rip interface {detail}

Description

Displays RIP-specific configuration and statistics for all VLANs.

Syntax Description

detail

Specifies detailed display.

Default

Show summary output for all interfaces.

Usage Guidelines

Summary includes the following information per interface:
  • This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches. name.
  • IP address and mask.
  • interface status.
  • packets transmitted.
  • packets received.
  • number of triggered updates.
  • cost.
Detail includes the following per interface:
  • VLAN name.
  • IP address and mask.
  • tx mode.
  • rx mode.
  • cost.
  • peer information (for each peer).
    • age.
    • version.
    • received packets.
    • received updates.
    • received bad packets.
    • received bad routes.
  • in policy.
  • out policy.
  • trusted gateway policy.
  • packets transmitted.
  • sent triggered updates.
  • packets received.
  • bad packets received.
  • bad routes received.

Example

The following command displays the RIP configuration for all VLANS:

# show rip interface

The following is sample output from this command:

# show rip interface
VLAN       IP Address         Flags  Sent     Rcvd     Triggered Cost
Packets  Packets  Updates
Flags: (f) Interface Forwarding Enabled, (i) Interface RIP Enabled
(n) Multinetted VLAN, (r) Router RIP Enabled

The following command displays RIP-specific statistics for all VLANs:

# show rip interface detail

History

This command was first available in ExtremeXOS 10.1.

Platform Availability

This command is available on all platforms with an Edge or Base license or higher as described in the ExtremeXOS 32.1 Feature License Requirements document.