Configures the LLDP port to advertise or not advertise MAC and physical layer capabilities to its neighbors. The capabilities include duplex and bit rate.
all | Specifies all ports on the switch. |
port_list | Specifies one or more ports or slots and ports. |
advertise | Specifies to send the information to neighbors. |
no-advertise | Specifies not to send the information to neighbors. |
No advertise.
When configured, the system advertises information about the speed capabilities, as well as autonegotiation support and status, of the LLDP port.
The following command configures all ports to advertise MAC/PHY capabilities to neighbors:
configure lldp ports all advertise vendor-specific dot3 mac-phy
This command was first available in ExtremeXOS 11.2.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.