Shows the status of Extended Edge Switching auto-configuration (partial automation) and, if applicable, switch port to bridge port extender (BPE) slot assignments.
vpex | Specifies Virtual Port Extender (VPEX). |
auto-configuration | Specifies the VPEX Auto-Configuration of cascade ports and VPEX slots. |
N/A.
None.
The following example displays output when there is no MLAG peer configured:
# show vpex auto-configuration VPEX Auto-Configuration: Enabled without MLAG support Virtual MLAG ID Configuration: Cascade
The following example displays output when an MLAG peer is configured:
# show vpex auto-configuration VPEX Auto-Configuration: Enabled with MLAG support Virtual MLAG ID Configuration: Cascade
The following example displays output when an MLAG peer is configured and an MLAG peer is down:
# sh vpex auto-configuration VPEX Auto-Configuration: Disabled Virtual MLAG ID Configuration: Cascade
This command was first available in ExtremeXOS 31.7
This command is available on ExtremeSwitching X465 and X590 series switches.