configure ospfv3 authentication (Authentication Trailer)

configure ospfv3 [{vlan} vlan-name | {tunnel} tunnel-name] authentication [keychain keychain-name | none]

Description

Configures Authentication Trailer with a manual key to provide authentication on OSPFv3 interfaces.

Syntax Description

ospfv3 Specifies OSPFv3 interface.
vlan Specifies OSPFv3 VLAN.
vlan-name Specifies an IPv6 configured This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches..
tunnel Specifies Layer 3 tunnel.
tunnel-name Specifies Layer 3 tunnel name.
authentication Specifies interface authentication.
keychain Specifies the set of authentication keys.
keychain-name Specifies the keychain name.
none Specifies no authentication (default).

Default

If not specified, no authentication is applied.

Usage Guidelines

Users can only add keychains that are already present in the system. To add a keychain, run the command create keychain keychain_name .

Example

The following example for VLAN "vlan1" applies authentication type Authentication Trailer:

# configure ospfv3 vlan1 authentication keychain ospfv3-keys1 

History

This command was first available in ExtremeXOS 31.3.

Platform Availability

This command is available on platforms with an Advanced Edge or Base license, or higher, as described in the ExtremeXOS 32.1 Feature License Requirements document.