configure pim state-refresh

configure pim {ipv4 | ipv6} state-refresh {vlan} [vlan_name | all] [on | off]

Description

Enables or disables the PIM-DM state refresh feature on one or all This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.s.

Syntax Description


ipv4	Specifies the IPv4 address family.
ipv6	Specifies the IPv6 address family.
`vlan_name`	Specifies a VLAN on which to enable or disable the PIM-DM state refresh feature.
on	Enables the PIM-DM state refresh feature on the specified VLANs.
off	Disables the PIM-DM state refresh feature on the specified VLANs.

Default

Disabled.

Usage Guidelines

When this feature is disabled on an interface, the interface behaves as follows:

State refresh messages are not originated.
State refresh messages received on the interface are dropped without processing.
State refresh messages received on other interfaces are not forwarded to the disabled interface.

Example

The following example enables the PIM-DM state refresh feature on VLAN blue:

configure pim state-refresh blue on

History

This command was first available in ExtremeXOS 12.4.

Platform Availability

This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the PIM feature, see the ExtremeXOS 32.1 Feature License Requirements document.