This command resets the stacking parameters configured with commands that use the stacking-support keyword.
This command has no arguments or variables.
N/A.
Run this command from the local node on which you want to reset stacking-support parameters.
configure stacking-support
To unconfigure the stacking-support parameters on the local node, use the following command:
unconfigure stacking-support The stacking-support configuration has been reset. The defaults will take effect at the next reboot of this switch.
This command was first available in ExtremeXOS 12.5.
This command is available on all platforms that support alternate stack port selection or permit disabling of the stacking-support option.