Enables the loop protection warning messages displayed when configuring specific EAPS parameters.
This command has no arguments or variables.
By default, loop protection warnings are enabled and displayed when configuring specific EAPS parameters.
This is a global EAPS command. You configure the warning message display on a per switch basis, not per EAPS domain.
Adding EAPS primary or secondary ring ports to a This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.
Deleting a protected VLAN
Disabling the global EAPS setting on the switch
Disabling an EAPS domain
Configuring an EAPS domain as a transit node
Unconfiguring EAPS primary or secondary ring ports from an EAPS domain
We recommend that you keep the loop protection warning messages enabled.
The following command enables the loop protection warning messages:
configure eaps config-warnings on
This command was first available in ExtremeXOS 11.4.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.