Deletes an entry from the unicast slave table for a PTP clock instance. This command is available only for boundary clocks.
|
boundary |
Boundary clock instance. |
|
unicast-slave |
IP addresses that are potential slave to the local clock. |
|
ipv4_address |
IPv4 address. |
|
vlan |
This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.. |
|
vlan_name |
Name of the specific VLAN to add for the PTP clock instance. |
The default configuration of clock port is slave mode.
Use this command to delete an entry from the unicast slave table for a PTP clock instance.
The following command removes a static unicast master entry from boundary clock:
# configure network-clock ptp boundary delete unicast-slave 192.168.1.1 vlan lpbk-gm
This command was first available in ExtremeXOS 15.1.
This command is available on the ExtremeSwitching X460-G2 platform.
Note
PTP commands can be used only with the Network Timing feature pack.