configure igmp snooping leave-timeout

configure igmp snooping leave-timeout leave_timeout_ms {{vlan} vlan_name} {{vr} vr_name}

Description

Configures the IGMP snooping leave timeout.

Syntax Description

leave_timeout_ms Specifies an IGMP leave timeout value in milliseconds.
vlan_name Applies the configuration only to the specified This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.. If no VLAN is specified, the configuration applies to all VLANs.

Default

1000 ms.

Usage Guidelines

The leave-timeout is the IGMP leave override interval. If no other hosts override the IGMP leave by the end of this interval, the receiver port is removed.

The range is 0 - 175000 ms (175 seconds). For timeout values of one second or less, you must set the leave-timeout to a multiple– of 100 ms. For values of more than one second, you must set the leave-timeout to a multiple of 1000 ms (one second).

Example

The following example configures the IGMP snooping leave timeout to one second:

configure igmp snooping leave-timeout 1000

History

This command was first available in ExtremeXOS 10.1.

Platform Availability

This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the IGMP snooping feature, see the ExtremeXOS 32.1 Feature License Requirements document.