Display global information for ERPS.
N/A.
N/A.
Use this command to display global information for ERPS.
# show erps ERPS Enabled: Yes ERPS Display Config Warnings: On ERPS Multicast Add Ring Ports: Off ERPS Multicast Send IGMP Query: On ERPS Multicast Temporary Flooding: Off ERPS Multicast Temporary Flooding Duration: 15 sec Number of ERPS instances: 1 # ERPS ring configuration : -------------------------------------------------------------------------------- Ring State Type East West Control-Vlan VID -------------------------------------------------------------------------------- R1 Protection R r 21 +20 cvl (1000) -------------------------------------------------------------------------------- where State: Init/Idle/Protection/Manual-Switch/Force-Switch/Pending Type: (I) Interconnected node, (N) RPL Neighbor, R) RPL Owner, (X) Ring node Flags: (n) Non-revertive, (r) Revertive, (+) RPL Protection Port, (^) RPL Neighbor Port (f) Force Switch Port, (m) Manual Switch Port
This command was first available in ExtremeXOS 15.1.
This command is available on all platforms supported in 12.6 and forward that are running ExtremeXOS.