Configures the router lifetime value sent in router discovery advertisements on the This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches..
vlan_name | Specifies an IPv6 configured VLAN. |
defaultlifetime | Specifies the router lifetime. Range is 0, or max-interval to 9000 seconds. |
1800 seconds.
This command configures the router lifetime value to be included in the router advertisement messages.
The value is specified in seconds and is either 0, or between max-interval and 9000 seconds. A value of 0 indicates that the router is not to be used as a default router.
After a host sends a router solicitation, and receives a valid router advertisement with a non-zero router lifetime, the host must desist from sending additional solicitations on that interface, until an event such as re-initialization takes place.
The following example configures the default-lifetime to be 3600 seconds for the VLAN "top_floor":
configure vlan top_floor router-discovery default-lifetime 3600
This command was first available in ExtremeXOS 11.2.
This command is available on the platforms listed for the IPv6 unicast routing feature in the ExtremeXOS 32.1 Feature License Requirements document.