show mvrp tag

show mvrp tag vlan_tag {ports {port_list}}

Description

Shows the port specific applicant and registrar states and the configured control values for all MVRP enabled ports.

Syntax Description

mvrp Multiple This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches. Registration Protocol.
tag The 802.1Q VLAN ID.
vlan_tag VLAN ID ranging from 1 to 4094 (default is 2).
port_list Port list separated by comma or "-".

Default

N/A.

Usage Guidelines

Use this command to show the port specific applicant and registrar states and the configured control values for all MVRP enabled ports. The registrar control value is derived as follows:

Example

# show mvrp tag 2        

Port    Applicant     Applicant     Registrar    Registrar             
        State         Control       State        Control   
        -----         ---------     ---------    ---------     ---------       
            9         VN            On            MT           Normal      
            11        QA            On            IN            Normal      
            13        QA            On            IN            Normal       

Applicant States:        
        AA     : Anxious active,        AN       : Anxious new,        
        AO     : Anxious observer,      AP       : Anxious passive,        
        LA     : Leaving active,        LO       : Leaving observer,        
        QA     : Quiet active,          QO       : Quiet observer,                   
        QP     : Quiet passive,         VN       : Very anxious new,                 
        VO     : Very anxious observer, VP       : Very anxious passive       

Registrar States:        
        IN     : In – Registered,       LV        : Leaving - Timing out,        
        MT     : Empty - Not Registered       
Applicant Control:        
        On     : Transmit On,          Off       : Transmit Off       

Registrant Control:        
        Fixed  : Statically added,     Forbidden : Forbidden VLAN,        
        Normal : Dynamically added    

History

This command was first available in ExtremeXOS 15.3.

Platform Availability

This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.