Displays the VPLS peer L2PT configuration and status of a service.
l2vpn | Specifies the Layer 2 Virtual Private Network. |
vpls | Specifies the Virtual Private LAN Service over MPLS. |
vpls_name | Specifies the VPLS VPN. |
vpws | Specifies the Virtual Private Wire Service over MPLS. |
vpws_name | Specifies the VPWS VPN. |
peer | Specifies the peer. |
ipaddress | Specifies the IPv4 address. |
l2pt | Specifies Layer 2 protocol configuration. |
detail | Specifies to show L2PT configuration and status in detail. |
Disabled.
Use this command to display the L2PT configuration and status of a service.
The following is an example of the show vpls peer l2pt command:
# show l2vpn vpls cust1 l2pt Interface L2PT Profile Name --------------- -------------------------------- 123.112.111.111 my_other_l2pt_prof
This command was first available in ExtremeXOS 15.5.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.