enable vpex

enable vpex

Description

Enables VPEX mode for using bridge port extenders (BPEs).

Syntax Description

vpex Specifies Virtual Port Extender (VPEX).

Default

N/A.

Usage Guidelines

This command enables VPEX mode and allows you to refer to ports in the slot:port notation in applicable commands. A reboot of the switch is required for the command to take effect. After rebooting, the CLI prompt changes to show that the switch is now slot 1 (for example):
Slot-1 VPEX X670G2-48x-4q.14 #

After enabling VPEX mode, to use the BPE, you need to configure the slot assignment for the BPE, using the command: enable vpex

VPEX mode is not compatible with stacking mode. Only one of these modes can be enabled at a time.

Example

The following example enables VPEX mode:

# enable vpex

History

This command was first available in ExtremeXOS 22.5.

Platform Availability

This command is available on ExtremeSwitching X465 and X590 series switches.