Configures the number of slices used by a profile in the look-up stage TCAM resources.
slices | Configures look-up stage TCAM resources. |
tci-overwrite | Configures look-up Stage TCAM resources used by profile with
tci-overwrite enabled. Note: The ExtremeSwitching X435 platform does not support
TCI-overwrite.
|
slices | Specifies the number of slices between 0 and 4. The default is 4. |
shared | Configures look-up stage TCAM resources. |
shared | Specifies the shared slice value (0–4). |
By default, the number of slices is 4.
This command only runs if policy is disabled.
This command enables you to allocate only the slice resources necessary and allow the rest to be used outside of policy. In a stack with slots having differing VCAP slice depths, each slot has the number of rules available as follows: numSlices * (VCAP slice depth)).
The following example configures policy to use 3 slices with tci-overwrite enabled:
# configure policy slices tci-overwrite 3
This command was first available in ExtremeXOS 30.4.
This command is available on ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620-x series switches.