Disables a VXLAN remote endpoint.
| virtual-network | Virtual overlay network. |
| remote-endpoint | Remote tunnel endpoint information. |
| vxlan | VXLAN virtual networks remote endpoint. |
| ipaddress | Specifies an IP address of a remote endpoint. |
| ipaddress | Specifies the IP address of the desired remote endpoint. |
| vr | Specifies a VR/VRF instance the remote endpoint is associated with. |
| vr_name | Specifies the desired existing VR/VRF instance the remote endpoint is associated with. Default is VR-Default. |
| all | Specifies all remote tunnel endpoints. |
If a VR is not specified, VR-Default is the VR.
Extreme Loop Recognition Protocol (ELRP) detects loops across VXLAN tunnels. If a loop is detected across the tunnel, ELRP takes down the VXLAN remote endpoint. You can use this command to disable a remote endpoint manually.
The following example disables the remote endpoint at 100.1.1.1 on VR-Default (not specified, command default):
# disable virtual-network remote-endpoint vxlan ipaddress 100.1.1.1
This command was first available in ExtremeXOS 22.4.
This command is supported on the ExtremeSwitching X465, X590, X695 series switches, and stacks with X465, X590, X695 slots only.