Allows you to access ldp-params subconfiguration mode to configure LDP parameters on an interface.
MPLS interface configuration mode
When you use this command, you can configure the LDP Hello interval and timeout parameters on the interface.
Use the no form of the command to remove the LDP parameter configuration.
MPLS is supported only on devices based on the DNX chipset family. For a list of such devices, see "Supported Hardware".
The following example accesses ldp-params subconfiguration mode.
device# configure terminal device(config)# router mpls device(config-router-mpls)# mpls-interface ethernet 0/2 device(config-router-mpls-interface-0/2)# ldp-params device(config-router-mpls-interface-0/2-ldp-params)#