Shows the status of Zero Touch Provisioning.
Privileged EXEC mode
This command displays the status of Zero Touch Provisioning (ZTP) on the device. When an attribute is unavailable or not applicable, the status is "None."
The ZTP History attribute shows the last 10 ZTP processes. However, if you run the fullinstall firmware download command, the ZTP history is deleted and the ZTP History Countvalue attribute is reset.
The following example shows output when the ZTP process is running.
device# show ztp status ZTP Status :IN-PROGRESS ZTP Interface up :eth0 IP Address Assigned :10.x.x.x ftp Server IP Address :10.x.x.x Transfer Mode :ftp ZTP Configuration File :ztp.conf clientid :EXTREMENETWORKS##SLX9150-48XT##XXXXXXXXXX Switch Configuration File :snowball_vlan.cfg , rootenable.py Firmware Directory :[/fw/slxos20.1.1_bld16/] firmware download state :start firmware fullinstall :no] ZTP Description msg :fwdl start ZTP History ... ZTP history countvalue:1 **1) ZTP firmware upgrade... ZTP fwdir [..x.x,anonymous,/fw/slxos20.1.1_bldxx/,a] proto [ftp]
The following example shows status when the ZTP process is not running and there is no history.
device# show ztp status ZTP Status :None ZTP Interface up :None IP Address Assigned :None ftp Server IP Address :None Transfer Mode :None ZTP Configuration File :None clientid :None Switch Configuration File :None Firmware Directory :None firmware download state :None firmware fullinstall :None ZTP Description msg :No status available ZTP History :No history available