Enables IPv6 PIM routing on an interface.
By default, IPv6 PIM routing is disabled on an interface.
Interface configuration mode
Important
Use the ipv6 router pim command to globally enable IPv6 PIM routing before enabling it on an interface.
Perform Layer 3 configuration for VLANs, Bridge Domains, or LAGs under their interfaces at the Layer 3 level.
The no ipv6 pim-sparse form of the command disables IPv6 PIM routing.
This example enables IPv6 PIM on a virtual Ethernet (VE) interface.
device# configure terminal device(config)# interface ve 30 device(config-if-ve-30)# ipv6 pim-sparse