client

Configures a Multi-Chassis Trunking (MCT) client for a cluster and access cluster client configuration mode.

Syntax

client client-name client-id

no client client-name client-id

client-name: Specifies the client name as an ASCII string. The name can be up to 64 characters in length.
client-id: Specifies the cluster client ID. The ID value range can be from 1 through 512.

Cluster client configuration mode

On both MCT nodes, you must configure the same client ID.

The no form of the command removes the client from the MCT cluster configuration.

The following example configures a cluster client.

device(config)# cluster MCT1 1
device(config-cluster-1)# client MCT1-client 200
device(config-cluster-client-200)#