Alters the timing of the existing configuration changeover.
Specifies the key-rollover-interval in seconds. Valid values range from 0 through 14400. The default is 300 seconds.
OSPFv3 router configuration mode
OSPFv3 router VRF configuration mode
In order to have consistent security parameters, rekeying should be done on all nodes at the same time. Use the key-rollover-interval command to facilitate this. The key rollover timer waits for a specified period of time before switching to the new set of keys. Use this command to ensure that all the nodes switch to the new set of keys at the same time.
The no form of the command resets the rollover interval to the default value of 300 seconds.
The following example sets the key rollover interval to 420 seconds.
device# configure terminal device(config)# ipv6 router ospf device(config-ipv6-router-ospf-vrf-default-vrf)# key-rollover-interval 420
The following example re-sets the key rollover interval to the default value.
device# configure terminal device(config)# ipv6 router ospf device(config-ipv6-router-ospf-vrf-default-vrf)# no key-rollover-interval 420