Displays configuration information and statistics for BGP4+ neighbors of the device.
Privileged EXEC mode
Use this command to view configuration information and statistics for BGP4+ neighbors of the device. Output shows all configured parameters for the neighbors. Only the parameters whose values differ from defaults are shown.
device# show ipv6 bgp neighbors Total number of BGP Neighbors: 1 '+': Data in InQueue '>': Data in OutQueue '-': Clearing '*': Update Policy 'c': Group change 'p': Group change Pending 'r': Restarting 's': Stale '^': Up before Restart '<': EOR waiting 1 IP Address: 2000::1, AS: 200 (EBGP), RouterID: 20.0.0.1, VRF: default-vrf State: ESTABLISHED, Time: 2h21m47s, KeepAliveTime: 60, HoldTime: 180 KeepAliveTimer Expire in 49 seconds, HoldTimer Expire in 143 seconds Minimal Route Advertisement Interval: 0 seconds PeerGroup: pg DYNAMIC neighbor belongs to the subnet range group: 2000::/64 Multihop-EBGP: yes, ttl: 1 RefreshCapability: Received Address Family : VPNV4 Unicast SendExtendedCommunity: yes Address Family : VPNV6 Unicast SendExtendedCommunity: yes Address Family : L2VPN EVPN SendCommunity: yes SendExtendedCommunity: yes Address Family : IPV4 Flowspec SendExtendedCommunity: yes Messages: Open Update KeepAlive Notification Refresh-Req Sent : 1 0 165 0 0 Received: 1 0 163 0 0 Last Update Time: NLRI Withdraw NLRI Withdraw Tx: --- --- Rx: --- --- Last Connection Reset Reason:Unknown Notification Sent: Unspecified Notification Received: Unspecified Neighbor NLRI Negotiation: Peer Negotiated VPNv4 unicast capability Peer Negotiated VPNv6 unicast capability Peer Negotiated L2VPN EVPN address family Peer Negotiated IPV6 unicast capability Peer configured for VPNv4 unicast Routes Peer configured for VPNv6 unicast Routes Peer configured for L2VPN EVPN address family Peer configured for IPV6 unicast Routes Neighbor ipv6 MPLS Label Capability Negotiation: Neighbor AS4 Capability Negotiation: Outbound Policy Group: ID: 4, Use Count: 1 BFD:Disabled Byte Sent: 3204, Received: 3166 Local host: 2000::2, Local Port: 179 Remote host: 2000::1, Remote Port: 8047 Maintenance Mode : Disabled G-Shut: Disabled Remote host: 98.0.0.1, Remote Port: 179