Enables the end-of-lib configuration mode.
MPLS LDP configuration mode
Use the no form of this command to remove this mode and attribute under it.
The end-of-lib mode contains all the attributes of the end of lib capability and notification. Also, when you enable the end-of-lib mode, you can determine whether the two RFCs 5561 and 5919 are enabled by the LSR.
MPLS is supported only on devices based on the DNX chipset family. For a list of such devices, see "Supported Hardware".
The following example enables the end-of-lib configuration mode.
device(config)# router mpls device(config-router-mpls)# ldp device(config-router-mpls-ldp)# eol device(config-router-mpls-ldp-eol)#