sflow agent-address
Configures the sFlow agent-ID address.
Syntax
sflow agent-address
{
ipv4
|
ipv6
[
ethernet
slot/plot
|
loopback
loopback-number
|
management
mgmt-id
|
ve
ve-inteface
]
}
Command Default
By default the sflow agent address is not configured.
Parameters
- ipv4
- Specifies an agent-address configuration for IPv4 collectors.
- ipv6
- Specifies an agent-address configuration for IPv6 collectors.
- ethernet
slot/plot
- Specifies an Ethernet slot and port. The only
supported slot value on the fixed form factor SLX devices is 0.
- loopback
loopback-number
- Specifies a loopback interface. Valid values range from 1 through 255.
- management
mgmt-id
- Specifies the management interface. The only
supported value is 0.
- ve
ve-inteface
-
Specifies a virtual Ethernet (VE) interface. Valid values range from 1 through 4096.
Modes
Global configuration mode
Usage Guidelines
Use the
no form of this command to remove the sFlow agent address configuration.
Examples
The following example configures the sFlow
agent-address globally. That is, it applies to all IPv4 collectors.
device# configure terminal
device(config)# sflow agent-address ipv4 ethernet 0/5
