mpls-interface

Configures MPLS on an interface and accesses MPLS interface sub-configuration mode to configure its parameters.

Syntax

mpls-interface { ethernet slot/port | port-channel number | ve number }

no mpls-interface { ethernet slot/port | port-channel number | ve number }

Parameters

ethernet slot/port: Specifies an Ethernet slot and port.
port-channel number: Specifies a port-channel interface.
ve number: Specifies the VE interface number.

Modes

MPLS configuration mode

Usage Guidelines

Use the no form of this command to remove the MPLS interface.

You cannot configure MPLS on a VE interface associated with a protocol based VLAN. The command is rejected, and an error message is displayed.

After you enable MPLS globally on the device, you can enable it on one or more interfaces.

MPLS is supported only on devices based on the DNX chipset family. For a list of such devices, see "Supported Hardware".

Examples

The following example configures MPLS on Ethernet interface 0/12.

device# configure 
device(config)# router mpls
device(config-router-mpls)# mpls-interface ethernet 0/12
device(config-router-mpls-if-0/12)# ldp-params
device(config-router-mpls-if-0/12-ldp-params)# exit
device(config-router-mpls-if-ethernet-0/12)# rsvp