Configure SLPP Globally

About this task

Enable the Simple Loop Prevention Protocol (SLPP) to detect a loop and automatically stop it.

Procedure

  1. In the navigation pane, expand Configuration > VLAN.
  2. Select SLPP.
  3. Select the Global tab.
  4. Select GlobalEnable.
  5. In TransmissionInterval, type a value for the time interval for loop detection.
  6. Select Apply.

Global Field Descriptions

Use the data in the following table to use the Global tab.

Name

Description

GlobalEnable

Activates or disables SLPP globally. The default is disabled.

TransmissionInterval

Configures the interval for which loop detection occurs. The interval is expressed in milliseconds in a range from 500–5000. The default value is 500.

Job aid

The following table provides the SLPP values.

Table 1. SLPP values

Enable SLPP

Setting

Access SMLT

Yes

Core SMLT

No

Primary switch

Packet Rx threshold

5

Transmission interval

500 milliseconds (ms) (default)

Secondary switch

Packet Rx threshold

50

Transmission interval

500 ms (default)