Configure Global Mirroring Actions with an ACL

Configure the global action to mirror packets that match an access control list (ACL).

Before you begin

Enter Global Configuration mode:

enable

configure terminal
Configure the global action for an ACL:

filter acl set <1-2048> global-action {monitor-dst-mlt <1–512>|monitor-dst-ports {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

Switch:1> enable

Switch:1# configure terminal

Configure the global action for an ACL:

Switch:1(config)# filter acl set 200 global-action monitor-dst-mlt 20

The following table defines parameters for the filter acl set command.


Variable	Value
`<1-2048>`	Specifies an ACL ID from 1–2048.
default-action <deny\|permit>	Specifies the global action to take for packets that do not match an ACL.
global-action {monitor-dst-mlt PT_MLT<1–512>\|monitor-dst-ports `{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}`	Specifies the global action to take for matching ACLs: monitor destination MLT—Configures mirroring to a destination MultiLink Trunking (MLT) group. monitor destination ports—Configures mirroring to a destination port or ports.