Configure VLAN Multicast Stream Limitation Members

Configure multicast stream limitation members on ports of a specific VLAN to limit the number of multicast groups that can join a VLAN.

Procedure

  1. Enter VLAN Interface Configuration mode:

    enable

    configure terminal

    interface vlan <1–4059>

  2. Configure multicast stream limitation members on a VLAN:

    ip igmp stream-limit-group {slot/port[/sub-port][-slot/port[/sub-port]][,...]} enable max-streams <0–65535>

Example

Enable multicast stream limitation on ports 2/1 to 2/3, and configure the maximum allowed number of streams to 6 for this interface.

Switch:1(config-if)#ip igmp stream-limit-group 2/1-2/3 max-streams 6

Variable definitions

Use the data in the following table to use the ip igmp stream-limit-group command.

Variable

Value

<0–65535>

Configures the maximum number of allowed streams for the specified ports on this VLAN. The range is from 0–65535 and the default is 4.

{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
9037809-01 Rev AA