Enable or disable FA Zero Touch Client Attachment

Use this procedure to enable or disable the global FA Zero Touch Client Attachment feature on an FA Proxy or Server. By default, FA Zero Touch Client Attachment support is enabled.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Enable an FA Zero Touch client:

    fa zero-touch-client standard <camera|phone|router|security-device|srvr-endpt|switch|video|virtual-switch|wap-type1|wap-type2> i-sid <1–15999999>

  3. Disable an FA Zero Touch client:

    no fa zero-touch-client standard <camera|phone|router|security-device|srvr-endpt|switch|video|virtual-switch|wap-type1|wap-type2>

Example

Switch:1(config)# fa zero-touch-client standard camera i-sid 1003
Switch:1(config)# no fa zero-touch-client standard camera 

Variable definitions

The following table defines parameters for the fa zero-touch-client standard command.

Variable

Value

camera

Specify element type to match camera.

phone

Specify element type to match phone.

router

Specify element type to match router.

security-device

Specify element type to match security-device.

srvr-endpt

Specify element type to match srvr-endpt.

switch

Specify element type to match switch.

video

Specify element type to match video.

virtual-switch

Specify element type to match virtual-switch.

wap-type1

Specify element type to match wap-type1.

wap-type2

Specify element type to match wap-type2.