Delete an ACL

Delete an ACL to remove an ordered list of filter rules.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Delete an ACL:

    no filter acl <1-2048>

    The system displays the following message:

    WARNING: All ACE entries under this ACL will be Deleted.
Do you wish to delete this ACL? (y/n)?
  3. Enter y.

Variable definitions

Use the data in the following table to use filter acl command.

Variable

Value

<1-2048>

Specifies the ACL ID.

enable

Enables the ACL state, and all associated ACEs. Enabled is the default state.

matchType <both|terminatingNNIOnly|uniOnly>
For inVsn ACL types, specifies the match type to associate with the ACL. Valid options are:

  • both for traffic ingressing on both UNI ports and network-to-network interface (NNI) ports terminating on this node

  • terminatingNNIOnly for traffic ingressing on NNI ports only and terminating on this node

  • uniOnly for traffic ingressing on UNI ports only

The default value is both.

name WORD<0-32>

Specifies an optional descriptive name for the ACL.

type <inVlan|inPort|outPort|inVsn>

Specifies the ACL type. The values inVlan, inPort, and inVsn are ingress ACLs, and outPort is an egress ACL.

A port-based ACL has precedence over a VLAN-based ACL.
9037809-01 Rev AA