View IP Source Guard Configuration on a Port

About this task

View IP Source Guard (IPSG) configuration on a port, with filters for IPv4 addresses.

Procedure

To enter User EXEC mode, log on to the switch.
View IPSG configuration:

show ip source verify interface gigabitEthernet [{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}]

Example

Switch:1>show ip source verify interface gigabitEthernet 1/1

====================================================================================
                             Source Guard Port Info
====================================================================================
PORT                     IPSC
NUM        ENABLE        ORIGIN             
------------------------------------------------------------------------------------
1/1        true          RADIUS
------------------------------------------------------------------------------------

All 1 out of 1 Total Num of Ip Source Guard entries displayed

Variable Definitions

The following table defines parameters for the show ip source verify interface gigabitEthernet command.


Variable	Value
`{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}`	Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.