Configure the Subject Identity on Fabric IPsec Gateway VM
About this task
Use this procedure to configure the subject parameters to identify the device.
Procedure
Example
Switch:1>enable Switch:1#virtual-service FIGW console FIGW>set certificate subject ExtremeLab DN "CN=subca5, OU=Test, O=Extreme, L=Town, ST=State, E=email@extremenetworks.com" FIGW>set certificate subject ExtremeLab key-label key1
Variable Definitions
The following table defines parameters for the set certificate subject command.
Variable |
Value |
---|---|
DN <name> |
Specifies the distinguished name. You can create a comma-separated list. |
key-label <key-label> |
Specifies the key name of the generated key pair. This parameter is optional. If you do not configure one, the switch generates one the same as the subject-label. |
<subject-label> |
Specifies the subject identity. You cannot use the following special characters:
|