Enable SNMP Trap Logging

Use SNMP trap logging to send a copy of all traps to the syslog server.

Before you begin

You must configure and enable the syslog server.

About this task

Note

The platform logs CLILOG and SNMPLOG as INFO. Normally, if you configure the logging level to WARNING, the system skips all INFO messages. However, if you enable CLILOG and SNMPLOG the system logs CLI Log and SNMP Log information regardless of the logging level you set. This is not the case for other INFO messages.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Enable SNMP trap logging:

snmplog enable
Optional: Disable SNMP trap logging:

no snmplog enable
View the contents of the SNMP log:

show logging file module snmplog

Example

Enable SNMP trap logging and view the contents of the SNMP log:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#snmplog enable
Switch:1(config-app)#show logging file module snmp
CP1  [02/06/15 22:39:58.530:UTC] 0x00004595 00000000 GlobalRouter SNMP INFO Boot
ed with file
CP1  [02/06/15 22:39:59.547:UTC] 0x00004603 00400003.67108870 DYNAMIC CLEAR Glob
alRouter SNMP INFO 2k card up(CardNum=1 AdminStatus=1 OperStatus=1)
CP1  [02/06/15 22:39:59.547:UTC] 0x00004603 00400003.67108870 DYNAMIC CLEAR Glob
alRouter SNMP INFO 2k card up(CardNum=2 AdminStatus=1 OperStatus=1)
CP1  [02/06/15 22:39:59.547:UTC] 0x00004603 00400003.67108870 DYNAMIC CLEAR Glob
alRouter SNMP INFO 2k card up(CardNum=3 AdminStatus=1 OperStatus=1)
CP1  [02/06/15 22:40:45.839:UTC] 0x000045e5 00400005 DYNAMIC SET GlobalRouter SN
MP INFO Sending Cold-Start Trap

Variable Definitions

The following table defines parameters for the snmplog command.


Variable	Value
enable	Enables the logging of traps. Use the command `no snmplog enable` to disable the logging of traps.