Configure the SPB-PIM Gateway Brouter Port Optional Parameters

Configure the SPB-PIM Gateway interface parameters on a brouter port.

Procedure

  1. Enter GigabitEthernet Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Configure the SPB-PIM Gateway brouter port HELLO interval:

    ip spb-pim-gw hello-interval <0-18724>

  3. Configure the SPB-PIM Gateway brouter port JOIN PRUNE interval:

    ip spb-pim-gw join-prune-interval <1-18724>

Variable definitions

The following table defines parameters for the ip spb-pim-gw command.

Variable

Value

hello-interval<0-18724>

Specifies the HELLO interval in seconds. The default value is 30 seconds.

join-prune-interval<1-18724>

Specifies the JOIN PRUNE interval in seconds. The default value is 60 seconds.