Change an OSPF Passive Interface Type

Change the interface type to designate the interface as either passive, NBMA, or broadcast.

Before you begin

  • Enable OSPF globally.

  • Ensure that the interface uses an IP address.

  • If the interface is currently an NBMA interface with manually configured neighbors, you must first delete all manually configured neighbors.

  • Change the VRF instance as required to configure OSPF on a specific VRF instance. The VRF must have an RP trigger of OSPF. Not all parameters are configurable on non-default VRFs.

Procedure

  1. In the navigation pane, expand Configuration > VLAN.
  2. Select VLANs.
  3. Select on the VLAN where the OSPF interface is created.
  4. Select IP.
  5. Select the IP Address where the OSPF interface is created.
  6. Select the OSPF tab.
  7. Clear the Enable check box to disable the OSPF interface.
  8. Select Apply.
  9. Modify the interface type to passive.
  10. Select the Enable check box.
  11. Select Apply.