Display the SPB-PIM Gateway VLAN Information

Use the following procedure to display the SPB-PIM Gateway VLAN interface information.

Procedure

To enter User EXEC mode, log on to the switch.
Display the SPB-PIM Gateway VLAN interface information:

show ip spb–pim–gw interface [vlan]

Example

Switch:1>show ip spb-pim-gw interface
=============================================================================================
                      Spb-pim-gw Interface - GlobalRouter

=============================================================================================

IF        ADDR            MASK            JPINT      HELLOINT   OPSTATE    ADMINSTATE
Vlan50    50.1.1.1        255.255.255.0   60         30         Disabled   Enabled   
Vlan123   123.1.1.1       255.255.255.0   60         30         Disabled   Disabled  
Vlan142   142.1.1.1       255.255.255.0   60         30         Enabled    Enabled   
Vlan400   100.1.1.2       255.255.255.0   60         30         Disabled   Disabled  

Total spb-pim-gw Interfaces Displayed 4/4

Variable definitions

The following table defines parameters for the show ip spb-pim-gw interface command.


Variable	Value
vlan-id	The VLAN ID of an interface to display.