Configure an ACE IPv6 Source Address

Configure ACE IPv6 source address entries to have the filter look for specific source IP addresses.

Before you begin

  • The ACL exists.

  • The ACE exists.

Procedure

  1. In the navigation pane, expand Configuration > Security > Data Path.
  2. Select Advanced Filters (ACE/ACLs).
  3. Select the ACL tab.
  4. Select the appropriate ACL.
  5. Select ACE.
  6. Select the appropriate ACE.
  7. Select IPv6.
  8. Select the Source Address tab.
  9. Select Insert.
  10. In the Oper field, select the operation type.
  11. In the List field, enter the source IP address.
  12. In the OperMask field, enter the operation mask value.
  13. Select Insert.

Source Address Field Descriptions

Use the data in the following table to use the Source Address tab.

Name

Description

AclId

Specifies the ACL ID.

AceId

Specifies the ACE ID.

Oper

The eq and mask parameters specify an operator for a field match condition: equal to or mask. The mask operator is an implied eq on the mask bits.

List

Specifies the source IP address.

OperMask

Specifies the mask value for the source IP address.