Delete Logical Interface Tunnel Configuration on Fabric IPsec Gateway VM

About this task

Perform this procedure to delete configuration of a specific logical interface tunnel on Fabric IPsec Gateway Virtual Machine (VM).

Procedure

Enter Fabric IPsec Gateway Configuration mode:

enable

virtual-service WORD<1-128> console

Note

Type CTRL+Y to exit the console.
Delete configuration of specific logical interface tunnel:

delete logical-intf-tunnel <1-255> < fe-tunnel-dest-ip | mtu | egress-shaping-rate>

Example

Deleting the destination IP address for Fabric Extend (FE) tunnel configured on the logical interface tunnel with ID 3.

Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW> delete logical-intf-tunnel 3 fe-tunnel-dest-ip

Variable Definitions

The following table defines parameters for the delete logical-intf-tunnel command.


Variable	Value
`<1-255>`	Specifies the unique ID of the logical interface tunnel.
fe-tunnel-dest-ip	Deletes the destination IP address that you configure on the logical interface tunnel.
mtu	Resets the Maximum Transmission Unit (MTU) value for the specific logical interface tunnel to the MTU value configured globally.
egress-shaping-rate	Deletes the egress shaping rate on the logical interface tunnel.