Delete a Dynamically Learned Route
About this task
Delete a dynamically learned route from the routing table if you do not want the switch to use the route. Exercise caution when you delete entries from the routing table.
Procedure
Example
Delete a dynamically learned route:
Switch:1>enable Switch:1#configure terminal Switch:1(config)#no ip route 192.0.2.32 255.255.255.0 198.51.100.31 dynamic
Variable Definitions
Use the data in the following table to use the show ip route commands.
|
Variable |
Value |
|---|---|
|
<A.B.C.D> |
Specifies the IP address of the route to the network. |
|
alternative |
Displays the alternative routes. |
|
count-summary |
Displays a summary of the number of routes learned from each routing protocol for each VRF. |
|
preference |
Displays the route preference. |
|
-s <A.B.C.D/X> |
Indicates the IP address and subnet mask for which to display routes. |
|
-s default |
Indicates the default subnet. |
|
static |
Displays the static route information. |
|
vrf WORD<1-16> |
Displays the route for a particular VRF. |
|
vrfids WORD<0-512> |
Displays the route for a particular VRF number. |
|
spbm-nh-as-mac |
Displays the spbm route next hop as mac. |
Use the data in the following table to use the no ip route command.
|
Variable |
Value |
|---|---|
|
<A.B.C.D A.B.C.D | A.B.C.D/X><A.B.C.D> |
Specifies the IP address, the subnet mask, and the next-hop IP address, respectively. Specify the IP address and mask for the route destination in one of the following formats:
|
|
dynamic |
Specifies that a dynamic route is to be deleted. |
|
enable |
Disables the route. |
|
local-next-hop enable |
Disables the local-next-hop option. |
|
preference |
Deletes the value of the route preference. |
|
next-hop-vrf WORD<1-16> |
Specifies the name of the next-hop VRF router. |