Configure the Maximum MAC Clients

Use this procedure to configure the maximum EAP and NEAP MAC clients supported on a port.

Procedure

Enter Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface vlan <1–4059>

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Set the maximum limit of allowed EAP and NEAP MAC clients supported on the port:

eapol multihost mac-max <1-8192>

Switch:1> enable
Switch:1# configure terminal
Switch:1(config)# interface GigabitEthernet 1/16
Switch:1(config-if)# eapol multihost mac-max <1-8192>

The following table defines parameters for the eapol multihost mac-max command.


Variable	Value
mac-max `<1-8192>`	Specifies the maximum number of EAP and NEAP MAC addresses allowed on the port. The maximum limit is 8192 MAC addresses.