Configure VRRPv3 Checksum

About this task

Perform this procedure to configure VRRPv3 checksum on either a brouter port or a VLAN.

Procedure

  1. In the navigation pane, expand Configuration > IP.
  2. Select VRRP.
  3. Select the V3 Checksum tab.
  4. Select Insert.
  5. In Interface, select Port or Vlan.
  6. Select the ports or VLANs from the list, and then select OK.
  7. Select a type of checksum computation.
  8. Select a VRRP version.
  9. Select Insert.

V3 Checksum Field Descriptions

Use the data in the following table to use the V3 Checksum tab.

Name

Description

Interface

Shows VRRPv3 information about a specified interface.

rcIpConfIfIndex

Shows the index value that uniquely identifies the interface to which this entry applies.

ChkSumComputation

Specifies the type of checksum computation, with Pseudo Header or without Pseudo Header.

VrrpVersion

Specifies the VRRP version as unspecified, v2, or v3.