Configure Additional Addresses on the VRRP Brouter Port

Before you begin

  • Assign an IPv6 address to the interface.

  • Enable routing globally.

About this task

Perform this procedure to configure the additional addresses for which the virtual router acts as a back up.

Procedure

  1. In the navigation pane, expand Configuration > Edit > Port.
  2. Select IPv6.
  3. Select the VRRP tab.
  4. Select AssociatedIPAddr.
  5. Select Insert.
  6. Type the address.
  7. Type the prefix length.
  8. Select Insert.
9037809-01 Rev AA