Configure the MLD Query Interval

About this task

Use this procedure to configure the query interval for the MLD interface.

Procedure

  1. Enter Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface vlan <1–4059>

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Configure the query interval for the MLD interface:

    ipv6 mld query-interval <1-65535>

Variable Definitions

The following table describes the variables for the ipv6 mld query-interval command.

Variable Value

<1-65535>

Indicates the frequency at which MLD host query packets transmit on this interface.