Enable IPv6 Multicast Route Statistics

Enable the collection of IPv6 multicast route statistics.

These statistics are not related to the interface (port) statistics. Rather, the statistics are displayed based on multicast group classification. By default, collection of multicast route statistics is disabled.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Enable the collection of IPv6 multicast route statistics.

ipv6 mroute stats enable
Optional: Set the IPv6 multicast route statistics to default:

default ipv6 mroute stats
Optional: Disable the collection of IPv6 multicast route statistics.

no ipv6 mroute stats
View the IPv6 multicast route statistics.

show ipv6 mroute stats [WORD<7-400> {Ipv6address[,Ipv6address][,...]}]

Note

The maximum number of multicast group IP addresses is 10.

Example:

Enable collection of IPv6 multicast route statistics:

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#ipv6 mroute stats enable

View the IPv6 multicast route statistics:

Switch:1#show ipv6 mroute stats

==========================================================================
                     Multicast Stats

==========================================================================
--------------------------------------------------------------------------
                     Statistics : Enabled

View the statistics for the multicast group IP address FF05::1:

Switch#show ipv6 mroute stats FF05::1

=====================================================================================
                         Multicast Stats - GlobalRouter

=====================================================================================
GroupAddress                SourceCounter      IngressPackets       IngressBytes    AverageSize
-------------------------------------------------------------------------------------
ff05:0:0:0:0:0:0:1          1                  1962750              2355300000     1200

View the statistics for multiple group IP addresses (up to a maximum of 10).

Switch#show ipv6 mroute stats FF05::1,FF05::2,FF05::3,FF05::4,FF05::5,FF05::6,FF05::7,FF05::8,FF05::9,FF05::a

=====================================================================================
                         Multicast Stats - GlobalRouter

=====================================================================================
GroupAddress               SourceCounter      IngressPackets       IngressBytes  AverageSize
-------------------------------------------------------------------------------------
ff05:0:0:0:0:0:0:1         1                  2027508              2433009600    1200
ff05:0:0:0:0:0:0:2         1                  2027507              2433008400    1200
ff05:0:0:0:0:0:0:3         1                  2027507              2433008400    1200
ff05:0:0:0:0:0:0:4         1                  2027507              2433008400    1200
ff05:0:0:0:0:0:0:5         1                  2027507              2433008400    1200
ff05:0:0:0:0:0:0:6         1                  2027505              2433006000    1200
ff05:0:0:0:0:0:0:7         1                  2027505              2433006000    1200
ff05:0:0:0:0:0:0:8         1                  2027505              2433006000    1200
ff05:0:0:0:0:0:0:9         1                  2027505              2433006000    1200
ff05:0:0:0:0:0:0:a         1                  2027505              2433006000    1200

Variable definitions

Use the data in the following table to use the show ipv6 mroute stats command


Variable	Definition
WORD`<7-400>` `{Ipv6address[,Ipv6address][,...]}`	Specifies the multicast group IP address for which to display statistics. The group IP address is in one of the following formats: a single IP address or a series of IP addresses. You can specify a maximum of 10 groups.