Configure the Metric Type for IS-IS Routes Using Global Redistribute Command

About this task

Use this procedure to set the IS-IS external metric-type using the global redistribute command for the following cases redistributing routes from other protocols into IS-IS.

Before you begin

You must configure the required SPBM and IS-IS infrastructure.
You must log on to the IS-IS router configuration mode in the CLI.

Procedure

Enter IS-IS Router Configuration mode:

enable

configure terminal

router isis
Set IS-IS metric type using global redistribute command:

redistribute direct metric-type {internal|external}
Enable the route policy

redistribute direct enable

Example

Set metric type for IS-IS routes using global redistribute command:

Switch:1> enable
Switch:1# configure terminal
Switch:1(config)# router isis
Switch:1(config-isis)# redistribute direct metric-type internal
Switch:1(config-isis)# redistribute direct enable

Variable Definitions

The following table defines parameters for the redistribute direct metric-type command.


Variable	Value
metric-type {internal\|external}	Specifies the IS-IS metric type: internal – permits or denies routes that are internal to the IS-IS domain. external – permits or denies routes that originate from an external routing protocol domain.