Display IKE Policies
Use the following procedure to display the configured IKE policies.
Procedure
Example
Switch:1#show ike policy ========================================================================================== IKE Policy ========================================================================================== Policy Addr Profile Name Type Local Address Remote Address Name ------------------------------------------------------------------------------------------ iketest3 IPv4 192.168.152.104 192.168.149.207 test v1pol IPv4 192.168.152.104 192.168.152.152 ikepro ========================================================================================== IKE Policy ========================================================================================== Policy Profile Revocation-Check peer-identity Name Version Auth-Method Pre-Shared Key Method name ------------------------------------------------------------------------------------------- iketest3 2 digital-cert ocsp v1pol 1 digital-cert ocsp ========================================================================================== IKE Policy ========================================================================================== Policy DPD Admin Oper Use IKE Name Timeout State State P2 PFS DH Grp DH Group IntfId ------------------------------------------------------------------------------------------ iketest3 300 enable up disable enable modp1024 3047 v1pol 300 enable up disable enable modp1024 3047
Variable Definition
The following table defines parameters for the show ike policy command.
Variable |
Value |
---|---|
policy WORD<1–32> |
Specifies the name of the policy to be displayed. |
laddr WORD<1–256> |
Specifies the local IPv4 or IPv6 address. |
raddr WORD<1–256> |
Specifies the remote IPv4 or IPv6 address. |