Configure Multi-area SPB Layer 3 Static I-SID Routed Multicast Redistribution Policy in Home Area

About this task

Perform this procedure to configure Multi-area SPB Layer 3 static I-SID routed multicast redistribution policy in the home area.

Note

Note

Routed multicast redistribution is available for IPv4 only. With the MAC learning disabled, the static data I-SID multicast redistribution policy takes precedence over the Layer 2 multicast redistribution.

Procedure

  1. In the navigation pane, expand Configuration > Fabric.
  2. Select MultiArea.
  3. Select the L3 MC Redist Home Static ISID List tab.
  4. Select Insert.
  5. In the Type field, select staticisid.
  6. Select Enable.
  7. In the IsidListName field, type the name of the I-SID list.
  8. In the Apply field, select apply.
  9. Select Insert.

L3 MC Redist Home Static ISID List Field Descriptions

Use the data in the following table to use the L3 MC Redist Home Static ISID List tab.

Name

Descriptions

Type

Specifies the layer 3 static I-SID routed multicast redistribution type. The default type is staticisid.

Enable

Enables layer 3 static I-SID routed multicast redistribution in the home area. The default value is disabled.

IsidListName

Specifies the name of the I-SID list. The default I-SID list name is htr.

Apply

Applies the Multi-area SPB layer 3 static I-SID routed multicast redistribution filters in the home area. The default value is noAction.